EXact PipeCut 170 Wartungshandbuch PDF herunterladen (Seite 10)

Attaching the pipe saw to the pipe

Open the pipe saw's gripper unit enough to suit the

diameter of the pipe by rotating the adjustment

handle located at the rear of the saw (Fig. E/1).

Position the pipe saw on top of the pipe so that the

edge of the lower blade guard is at the cutting mark.

Fasten the pipe saw to the pipe by turning the gripper

adjustment handle until the gripper grips firmly the

pipe to be cut (Figure E/2). Hold the pipe in place

and ensure that pipe saw moves freely in the direction

the pipe is fed. For sake of safety ensure the pipe

saw leads are to the left of the pipe saw. The pipe

saw is now ready for cutting.

Piercing the pipe wall

Grip the gripper firmly with your right hand and place

your left foot on top of the pipe approximately 50cm

from the pipe saw. Turn the saw until it leans slightly

forward (Figure H). When starting the motor, first

of all release the power-switch locking lever (Fig

F/1) and push the power switch all the way down

(Fig F/2). Before starting to saw, wait until the blade

reaches full speed. Pierce the pipe wall by pressing

pipe saw operating handle downwards slowly and

evenly until the blade has cut through the pipe wall

(at this stage the pipe must not rotate) and the motor

unit is locked in the sawing position (Fig H/1).. Look

at the UNLOCK button during the piercing operation.

When UNLOCK button is locked, i.e. the yellow

mark disappears (Fig G), pipe saw is locked in the

sawing position, and you can safely start sawing

around the pipe.

Sawing around the pipe

Start sawing by feeding the pipe saw forward and

fix the pipe with your left foot (Fig H/3).. After that

release the pipe (remove your left foot from the pipe)

and turn the pipe saw backwards, whereby the pipe

will also be rotated backwards (Fig J). Start a new

feeding movement, and feed continuously forward

ca. 1/6 of the pipe's circumference. Repeat until the

pipe is cut off (Fig K).

Operation

Fig E

Fig F

Fig G

Fig H

Cutting mark

Cutting point

1 2 ... 5 6 7 8 9 10 11 12 13

Kommentare zu diesen Handbüchern

Keine Kommentare

EXact PipeCut 170 Wartungshandbuch Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Elektrowerkzeuge EXact PipeCut 170